British Berkefeld®  
high quality products  
line decor
  
line decor

 
 
 

 
 

PF-4 Reduction Elements: Phone us +64 9 418 2123 Auckland

PF-4™ Post Filter Reduction Elements – Set of 4

PF-4 reduction elements are designed for use in conjunction with Super Sterasyl™ ceramic filtration elements to remove or reduce the following unwanted elements found in drinking water.

  • Fluoride
  • Lead
  • Arsenic
  • MTBE (Methyl-tertiary-butyl-ether)
  • DBCP (Dibromo-chloro-propane)
  • THMs (trihalomethanes)
  • Herbicides & Pesticides 
  • Heavy Metal ions

Length: 15.24

Width:  6.35 cm

REPLACEMENT:

Under normal conditions it is recommended that PF-4™ elements be replaced at six-month intervals. (Actual capacity is dependent on the presence of other competing contaminants in the source water. High levels of total organic carbons, volatile organic compounds or certain inorganic minerals may reduce the capacity and efficiency of these elements.).

USAGE

Do not boil this element.

TECHNICAL INFORMATION:

MTBE:

The PF-4™ is manufactured to exceed ANSI/NSF Standard 53 which requires that MTBE be reduced by at least two thirds from an influent rate (water going in) of 15ppb to an effluent rate (water going out) of less than 5ppb (> 95% reduction*).

LEAD:

Tests have shown that when 2000 gallon (7,600 litres) of influent water at a concentration of lead of 150-200 ppb pass through 200 grams of media at a flow rate of 1 gpm (3.8 lpm), the lead level was reduced to less than 1ppb (>99% reduction).

FLUORIDE:

Testing for fluoride was based on 20-30ppm of the ion in the influent aqueous solution at a flow rate of no more than 3 gpm (11 lpm) per cubic foot of media. Results of < 1ppm of the fluoride ion in the effluent were typical for the media (>95% reduction). Under optimum conditions, effluent concentrations of less than 50 ppb were readily achieved (>99.75% reduction).

MTBE (Methyl-tertiary-butyl-ether)

is the most common oxygenated fuel additive used in reformulated gasoline. Contamination of groundwater with MTBE is a rapidly growing problem in 49 U.S. states. In drinking water, even trace amounts of MTBE can cause taste and odour problems, which may lead to nausea and dizziness. The potential long-term health effects of MTBE are not understood at this time, however, initial studies indicate MTBE may cause kidney and liver problems. MTBE removal from water is a challenge because it is very soluble in water and must compete with other organics for binding sites on the filter medium. These other contaminants (BTEX - and TOC - total organic carbons) are adsorbed more readily, and MTBE often slips by standard carbon filters, ending up in the filtered water. The PF-4™ filter has been specifically designed to remove MTBE from drinking water when used in conjunction with Super Sterasyl™ ceramic filtration elements. The media within the Super Sterasyl™ filters, in the upper chamber, capture the more strongly adsorbed BTEX and TOC's.

This permits the downstream PF-4™, secured as a post filter, to more efficiently remove MTBE.

 

Available for Purchase online Email us or Phone us +64 9 418 2123 Auckland

 
 

 

 





 


PF-4 Filter Reduction